FAQ

What is the spool cycle?

This function is offered on selected miscea models.

The automatic spool function is designed to prevent clogging of the soap and disinfectant tubes and to prevent the waterline from being infected by legionella and other waterborne bacteria.

The automatic spool function will initiate after a minimum amount of time the soap or disinfectant has not been in use. This has been set by default at 2 weeks.

If the water, soap or disinfectant has not been in use for 2 weeks while connected to a power supply, the system will perform the following steps on the liquid that was last used 2 weeks ago:

  • Step 1: The soap or disinfectant pump will operate for 30 seconds
  • Step 2: Cold water flows for 60 seconds.

Note: It is possible to change the frequency of the auto spool function for more frequent water flushing, however it is not possible to change the frequency of the auto spool function for soap and disinfectant flushing.